V12 Torpedo Mini Flying Whistling Rocket Throwing Toy Game ~ Colour Varies

Product Information

If one has legal access to the necessary chemicals, I'll describe a safe way to make a flash report with one of these cans. But first, I'll detail three alternatives for making a report without flash powder.

Prior to flight, the tape is completely removed from the motor's bottom, and the Visco fuse is installed through the fuse hole. valign="top"| [7] [8]Insert the rammer with the hole into the tube and press the mix. Repeat this process until the rammer has cleared the spindle.

Drilling the Fuse Hole

After a couple of hours of drying over the pot of warm water, the fuel will be dry, will stop smelling of Coleman fuel, and will resemble grayish-green sand. I use my gloved hands to break up fuel clumps as it is drying. If the optional large pan of hot water will be used to dry the final mixture, the large pan of water should be put on to heat at this time. Using both gloved hands, clean as much of the mixture as possible off of your gloves into the bowl. Your gloves may be removed at this time and placed to the side to dry. When dry, any fuel remaining on your gloves may be easily removed. If I plan to have a passfire hole, I usually drill the hole down through the center of the clay bulkhead into the fuel. But, I don't want to drill into any fuel containing titanium; so I'll cap any titanium-fuel off with 1/8-inch of plain fuel (no titanium in it). Hand-twist-drilling into that is safer. Warning: Never use a power drill to create the passfire hole. The friction and heat caused by such fast drilling could ignite the motor. Only use hand twisting on the drill bit to create the hole.

Inspect the powder for white granules among the red. The presence of white granules indicates that the ingredients were not properly mixed in Step 7. The correction is to thoroughly "wet" the mixture with Naphtha and repeat Steps 7, 8, and 9. The hollow drift is used to press the increments of fuel, until the fuel is above the spindle. All the increments are pressed to 7500-psi (pounds per square inch) on the composition.

Conclusion

Slightly offtopic, but I tried using granulated whistle in an experimental squib yesterday. 1/4" by 2" card tube three quarters filled, e-match, glued endplugs. It worked well - not too much light or smoke output and a really loud bang. Could be useful for small scale SFX... WARNING: GO OUT OF DOORS!!! DO NOT PERFORM THE FOLLOWING STEPS INSIDE!!! STAY AWAY FROM OPEN FLAMES, SPARKS, OR OTHER POSSIBLE IGNITION SOURCES!!! NAPHTHA IS FLAMMABLE.